How to Propagate String of Pearls, Step by Step
How to propagate string of pearls is often a rescue question: the top of the pot has gone bald, or a few strands are shrivelling and you are afraid of losing the whole plant. Take heart. String of pearls roots readily from its own strands, and a few cuttings laid on fresh mix can most often give you a fuller plant than the one you started with.
Quick answer: cut a healthy strand 8–12 cm long, strip the pearls from the bottom few centimetres, and lay that bare stem on or just under slightly moist cactus mix so the nodes touch it. Keep it bright and barely moist; roots usually form in 2–4 weeks in spring or summer. Water and single pearls can work, but more slowly and less surely.
Why Strands Root So Easily
In the wild, string of pearls trails along the ground and roots wherever a stem touches the soil, University of Wisconsin–Madison Extension explains. A cutting does the same thing in a pot: each node, the point where a pearl joins the stem, can grow roots when it rests on moist mix. That is why the method is to lay strands down rather than to stand them up in water.
How to Take and Root the Cuttings
- Pick healthy strands with firm, round, green pearls. Avoid shrivelled or mushy sections.
- Cut 8–12 cm lengths with clean scissors. Wisconsin gives 3 to 4 inches for a stem tip cutting, NC State 3 to 5.
- Strip the bottom pearls. Wisconsin says to remove three or four, leaving bare nodes.
- Lay them on the mix. Use a shallow pot of gritty cactus mix, slightly moist. Lay the bare part on the surface or lightly cover it, and pin it down with a bent paper clip so the nodes touch.
- Mist, do not soak. Wisconsin advises misting the surface until roots are established rather than watering heavily, because overwatering and root rot are what kill this plant.
- Give it bright light, near a sunny window but out of hot afternoon sun through glass.
A gentle tug tells you when it has rooted: the strand stays put. From then on, water it like the parent, thoroughly and only when the top of the mix is dry.
String of pearls has shallow roots, so a wide, shallow pot with holes in the bottom suits cuttings laid on the surface. It dries quickly, which is what keeps the pearls from rotting.
Affiliate link — GrowersGuide.ca may earn a commission on qualifying purchases, at no extra cost to you. See our affiliate disclosure.
String of Pearls in Water
Water propagation is popular, and it can work. It is also the easiest way to rot a cutting, because the pearls are water-storing leaves that soften when they sit wet. Neither Wisconsin nor NC State describes rooting it in water; both describe moist mix.
- If you try it, only the bare stem goes in the water. Keep every pearl above the line.
- Change the water every few days and keep the jar bright, out of direct sun.
- Move the cutting into gritty mix as soon as short roots appear, and keep that mix only barely moist for the first week or two.
Can You Grow One From a Single Pearl?
Sometimes. NC State Extension calls dropping a leaf onto the mix a slower and less reliable form of propagation. A single pearl with a scrap of stem may root, but it can take a long time to make a strand. If a few pearls fall off while you work, scatter them on the pot anyway; just do not count on them.
Saving a Plant That Is Dying
When a string of pearls goes downhill, the cause is usually rot from wet mix, and an old plant may simply be wearing out: NC State notes they tend to die back after several years and suggests starting fresh from cuttings rather than reviving the old plant. Cut the healthiest strands, discard anything mushy, and root them in new cactus mix in a clean pot. Our string of pearls care guide has a symptom table for shrivelled, mushy and brown pearls.
When to Do It in Canada
Spring and summer, when cuttings root in a few weeks. Late winter works once the days are clearly lengthening, in March.
December and January are slow. On the shortest day, Toronto gets 8h55 of daylight and Edmonton 7h27, worked out from each city’s latitude. A cutting on cold, damp mix in that light can sit for weeks and rot before it roots. If you must take cuttings then, keep them warm, away from cold glass, and lean toward too dry rather than too wet.
Pets
The ASPCA plant database has no entry for string of pearls, so there is no listing either way. The ASPCA’s own article on succulents says that if it is eaten it can cause stomach upset, mainly vomiting, and lethargy. University of Wisconsin–Madison Extension calls the leaves slightly toxic and notes the sap can irritate sensitive skin. Hanging pots and trays of cuttings both belong out of reach. If a pet eats part of a plant, call your vet, ASPCA Animal Poison Control or Pet Poison Helpline.
Frequently Asked Questions
How do you propagate string of pearls?
From stem cuttings. Cut a strand 8–12 cm long, strip the pearls from the bottom few centimetres, and lay that bare part on, or just under, slightly moist cactus mix so the nodes touch it. University of Wisconsin-Madison Extension says roots develop at each node; mist the surface rather than watering heavily until they do.
Can you propagate string of pearls in water?
Some people do, but it is not the method extension sources describe, and string of pearls rots easily. The surer way is to lay the strand on moist cactus mix, where it roots at the nodes in a few weeks. If you try water anyway, keep the pearls above the water line and move the cutting to gritty mix as soon as short roots appear.
Can you grow string of pearls from a single pearl?
Sometimes, slowly. NC State Extension says dropping a leaf onto the potting mix is a slower and less reliable way to propagate it. A strand cutting with several nodes is far quicker and much more likely to work.
How long does string of pearls take to root?
Usually 2–4 weeks in spring or summer. In a Canadian winter it can take much longer, because short days give the cutting little light to grow with.
How do I save a dying string of pearls?
Take cuttings from the healthy strands, with firm green pearls, and root them in fresh, dry-ish cactus mix. NC State notes that older plants tend to die back after several years and suggests starting new ones from cuttings rather than trying to revive the old plant.
How do I make my string of pearls fuller?
Lay several cuttings back onto the surface of the same pot, coiled around the bare top. Each one roots where its nodes touch the mix, and the pot fills in from the centre.
For watering by season and winter light once your cuttings are growing, see string of pearls care. Its trailing cousin has its own guide: string of hearts propagation.
Sources
- University of Wisconsin–Madison Extension, String of Pearls, Curio rowleyanus — cuttings, rooting at nodes, misting, toxicity.
- NC State Extension, Curio rowleyanus — stem cuttings, single leaves, older plants.
- ASPCA, Are succulents safe to have around pets?