Loading…

Umbrella Plant Propagation: Cuttings and Air Layering

Umbrella plant propagation and pruning are really one job. A schefflera that has stretched toward the window needs cutting back, and the stems you cut off are the start of new plants. Here is how to root them, which method suits which stem, and why a Canadian winter is the wrong time to try.

Quick answer: in spring or summer, wear gloves and cut a stem tip 8–15 cm long with at least two nodes. Keep two or three leaves, set it 2.5–7.5 cm deep in pre-moistened rooting mix, cover it with a clear bag and give it bright light out of direct sun (University of Illinois Extension). For a tall, bare stem, air layer the top before you cut it: Iowa State Extension says lanky plants that need pruning are good candidates.

Which Method?

MethodWhat you needBest for
Stem cuttingA soft or semi-firm tip with a few leavesTips removed when you prune
Leaf-bud cuttingOne leaf, its stalk and a short piece of stem with a budMany new plants from little material
Air layeringA firm stem, still attachedA tall, bare stem you want to shorten safely

University of Illinois Extension lists these three for schefflera. Clemson and NC State Extension also list seed, but schefflera seed is rarely sold and we found no extension guide to sowing it, so it is not covered here.

Gloves on. NC State Extension says the sap of the umbrella tree can irritate skin, and the ASPCA lists schefflera as toxic to dogs and cats. Gather up the offcuts as you go.

Stem Cuttings, Step by Step

These steps follow University of Illinois Extension’s guide to houseplant cuttings.

  1. Take the cutting in spring or summer, while the plant is growing. Illinois gives 8–15 cm (3–6 inches), with at least two nodes and not more than six. A tip usually roots fastest.
  2. Make a clean cut and keep two or three leaves. Remove any leaf that would end up below the mix.
  3. Rooting hormone is optional. Illinois says it shortens rooting time and helps harder-to-root plants; a woody schefflera stem is a reasonable place to use it.
  4. Plant it 2.5–7.5 cm (1–3 inches) deep in pre-moistened rooting mix; make the hole first with a pencil, then firm the mix around the stem.
  5. Cover it with a clear plastic bag to keep the humidity high, and set it in bright light, not direct sun.
  6. Pot it up when the roots are about 2.5 cm (1 inch) long. Illinois says tougher stems may take 10–14 days or longer; a woody schefflera stem in a cool room can take several weeks.

Water instead of mix? A schefflera cutting may root in a jar, but Illinois Extension does not recommend it: roots formed in water are weaker and adapt less easily to potting mix.

Recommended
Rooting Hormone for Cuttings

Optional, and most useful on a firm, woody stem. Illinois Extension says rooting hormone shortens rooting time and helps cuttings that are slow to root. Pour a little into a separate dish and follow the label.

Browse on Amazon.ca →

Affiliate link — GrowersGuide.ca may earn a commission on qualifying purchases, at no extra cost to you. See our affiliate disclosure.

Leaf-Bud Cuttings

Illinois Extension describes a leaf-bud cutting as a leaf blade, its stalk and a short piece of stem with a bud, and says it lets you make many cuttings from a small amount of plant. Illinois gives no step-by-step for it; the usual way is to cut a section of stem with one leaf attached, keeping the bud where the leaf stalk meets the stem. Insert the stem piece so the bud sits at or just below the surface of the moist rooting mix, then treat it like a stem cutting: clear cover, bright indirect light. Each leaf-bud cutting gives one new plant.

Air Layering a Leggy Stem

Iowa State University Extension says large or lanky plants that need pruning back are good candidates for air layering, which grows roots on a stem before you cut it. Schefflera is a dicot, so use Iowa State’s ring method:

  1. Choose a point about 30–45 cm (12–18 inches) below the tip of the stem and remove the leaves right there.
  2. Cut all the way around the stem, down to the woody centre. Make a second ring cut about 2.5 cm (1 inch) below it, join them with a third cut and peel off the ring of bark. Scrape the exposed wood lightly.
  3. Dust it with a little rooting hormone if you like.
  4. Pack one or two handfuls of moist sphagnum moss around the wound, wrap it in clear plastic so no moss sticks out, and tie it above and below.
  5. Roots should show in the moss in several weeks, Iowa State says, and some plants take months. Keep the moss damp.
  6. Once there is a good mass of roots, cut the stem just below the bottom tie and pot the new plant, moss and all, in ordinary potting mix.

Iowa State notes that most plants send out new buds just below the cut, so the old stem becomes bushier as well.

When to Do It in Canada

Spring or summer. Illinois Extension says stem cuttings are usually taken while the plant is actively growing, and Iowa State gives early spring as the ideal time for layering.

Winter is slow. On the shortest day, Toronto gets 8h55 of daylight and Edmonton 7h27, worked out from each city’s latitude. A cutting taken then can sit for weeks; keep it warm and off cold window glass, since Clemson Extension wants scheffleras above 16 °C at night.

What Goes Wrong

The cutting drops its leavesIt is losing water faster than it can take it up. Keep it under the clear bag, out of direct sun and away from heating vents. A stem that stays firm and green can still root.
The base goes black and softToo wet or too cold. NC State says soft rot occurs when the soil is too wet. Cut above the soft part and start again in fresh, just-moist mix.
No roots after weeksCommon with a woody stem in a cool room. Leave it while the stem is firm; next time, try rooting hormone, or air layer instead.

Pets

The ASPCA lists schefflera as toxic to dogs and cats, with calcium oxalate crystals as the toxic principle and oral irritation, intense burning of the mouth, lips and tongue, excessive drooling, vomiting and difficulty swallowing as the signs. Its separate umbrella tree entry says the most common effects are mild vomiting and diarrhea. NC State Extension adds that the sap can irritate skin, so wear gloves when you cut. If a pet eats part of a plant, call your vet, ASPCA Animal Poison Control or Pet Poison Helpline.

Frequently Asked Questions

How do you propagate an umbrella plant?

Clemson Extension lists seed, cuttings and air layering, and University of Illinois Extension lists stem cuttings, leaf-bud cuttings and air layering for schefflera. For a home grower, a stem cutting from a pruned tip is the simple method; air layering is the surer one for a tall, bare stem.

Can you propagate an umbrella plant in water?

A cutting may root in water, but University of Illinois Extension does not recommend it: roots formed in water are weaker and adapt less easily to potting mix than roots formed in a rooting medium. Use moist rooting mix under a clear cover instead.

How long do umbrella plant cuttings take to root?

Illinois Extension says plants with tougher stems may take 10 to 14 days to root, and woody stems can take longer, especially in a cool room. Pot the cutting up when its roots are about 2.5 cm (1 inch) long.

How do I propagate a leggy umbrella plant?

Iowa State University Extension says large or lanky plants that need pruning back are good candidates for air layering. Root the top while it is still attached, cut it off once it has roots, and the old stem usually branches below the cut. Smaller stems can simply be cut back just above a leaf, as Clemson Extension advises, and the tips rooted as cuttings.

When should I propagate an umbrella plant in Canada?

Spring or summer. Illinois Extension says stem cuttings are usually taken while the plant is actively growing, and Iowa State gives early spring as the ideal time for layering. In a dim Canadian winter, cuttings root slowly.

For light, watering, drooping and pruning once your new plants are growing, see umbrella plant care in Canada. Another plant you rescue by cutting a bare stem: dieffenbachia propagation.

Sources

More Houseplant Propagation Guides

Spider Plant Propagation → Babies in water or soil, and division Snake Plant Propagation → Division, rhizomes and leaf cuttings Pothos Propagation → Node cuttings in water or soil Monstera Propagation → Node cuttings and air layering Fiddle Leaf Fig Propagation → Stem cuttings and air layering Jade Plant Propagation → Stem and leaf cuttings, dried first ZZ Plant Propagation → Division and slow leaf cuttings Prayer Plant Propagation → Division and stem cuttings in water Peperomia Propagation → Leaf and stem cuttings, and division String of Hearts Propagation → Tubers and vine cuttings, in soil or water Peace Lily Propagation → Division of the crowns, in spring Aloe Vera Propagation → Pups, and why leaves rarely work String of Pearls Propagation → Strands laid on soil, or in water Rubber Plant Propagation → Tip cuttings and air layering Hoya Propagation → Stem cuttings with a node, in water, moss or mix Dieffenbachia Propagation → Tip and cane cuttings, and air layering

Was this guide helpful?

Tap or press a star to rate

🌱 Free Newsletter

Get New Guides Before Anyone Else

Planting reminders for your city, new calculators, and Canadian growing guides — free, no spam.

Suggest what we write next →

⭐ Most Popular

Weather data by Open-Meteo.com (CC BY 4.0) · © OpenStreetMap contributors

As an Amazon Associate, GrowersGuide.ca earns from qualifying purchases. See our affiliate disclosure.