Transplanting Lilacs and Growing Them from Suckers
Updated November 2026
Transplanting lilacs comes up for two reasons: a lilac is in the wrong place, or someone wants a piece of a family lilac, the one at a grandparent's farm or an old house. The first means moving the whole shrub; the second is easier, because lilacs send up suckers from their roots, and a rooted sucker is a new lilac you can dig and replant.
GrowersGuide.ca is reader-supported. When you buy through links on this page, we may earn an affiliate commission — at no extra cost to you. See our affiliate disclosure.
Quick answer: transplanting lilacs
When: while dormant, in early spring before the buds break or in fall after the leaves drop. Whole shrub: tie up the stems, dig a root ball about half the distance from the outer branches to the centre and 30–38 cm deep, and replant at once at the same depth; only shrubs about 1.5 m tall or less are practical by hand. From a sucker: dig a rooted shoot from an own-root lilac, cut it free with a spade, replant, water and mulch. Expect few flowers for a year or two.
When to Transplant a Lilac
Iowa State Extension's rule for lilacs and other deciduous shrubs is to move them while dormant: early spring before growth begins, or fall after the leaves drop. In Canada, early spring is usually the safer of the two, because a lilac moved in fall has only a few weeks to root before the ground freezes, and on the Prairies that can be very little time. Never move one in full leaf in summer.
The table gives a rule-of-thumb spring window for each city, computed from its frost data: about 4 to 6 weeks before the average last spring frost, when the ground has usually thawed. If the soil is still frozen or waterlogged, wait. For a fall move, wait until the leaves have dropped, usually around or after the first fall frost.
| City | Move in spring (rule of thumb) | Average first fall frost |
|---|---|---|
| Victoria | March 3–17 | November 5 |
| Vancouver | February 12–26 | November 4 |
| Kelowna | April 4–18 | September 23 |
| Calgary | April 14–28 | September 10 |
| Edmonton | April 10–24 | September 11 |
| Saskatoon | April 10–24 | September 15 |
| Regina | April 16–30 | September 11 |
| Winnipeg | April 12–26 | September 22 |
| Thunder Bay | April 22–May 6 | September 15 |
| Toronto | March 23–April 6 | October 9 |
| Ottawa | March 26–April 9 | October 2 |
| Montréal | March 18–April 1 | October 9 |
| Quebec City | March 30–April 13 | October 1 |
| Fredericton | April 4–18 | September 24 |
| Halifax | March 27–April 10 | October 17 |
| St. John's | April 20–May 4 | October 15 |
How to Transplant a Lilac Bush
First, size it up. Iowa State Extension advises home gardeners to move only deciduous shrubs about 1.5 m (5 ft) tall or less; root balls over about 60 cm (2 ft) across are extremely heavy and need machinery. A bigger lilac needs a professional with a tree spade, or it is far easier to start again from one of its suckers (below).
- Prepare the new spot first: full sun, 6 hours or more, well-drained soil, and room for the mature size (University of Minnesota Extension).
- Water ahead. If the soil is dry, water the lilac thoroughly 3 to 4 days before digging, so the soil holds together around the roots.
- Tie up the stems with twine, pulling them up and in, so you can get at the base.
- Mark the root ball: Iowa State Extension gives a radius of about half the distance from the outer branches (the dripline) to the centre of the shrub.
- Dig a trench around it with a spade, 30–38 cm (12–15 in) deep, then cut underneath to round off the ball.
- Wrap it in burlap: tip the ball to one side, slide burlap under, lower it back and tie the burlap tight. Lift and carry it by the ball, never by the stems.
- Replant at once in a hole about twice as wide as the ball and as deep as the ball is tall, so the lilac sits at the same depth as before. Cut away the exposed burlap when the hole is two thirds full, finish backfilling, and water thoroughly.
Commonly used for moving a shrub: a sheet of natural burlap holds the root ball together while you lift and carry it, and the exposed top can be cut away once the lilac is in its new hole. Check the listing for the width; a root ball needs a piece several times its diameter.
Affiliate link — GrowersGuide.ca may earn a commission on qualifying purchases, at no extra cost to you. See our affiliate disclosure.
Propagating Lilacs from Suckers
A sucker is a shoot that grows from a bud on a lilac's root, often a little way out from the main clump; University of Minnesota Extension notes that lilacs usually produce them. New Mexico State University Extension explains that once a sucker is established it can be dug and transplanted, and that it is genetically identical to the root it grew from. Because lilacs are usually not grafted, the new plant is normally the same lilac.
- Pick a sucker 30–60 cm tall that has grown for a season or two, ideally one a little away from the main stems, where it is easier to dig.
- Time it for when the lilac is dormant. New Mexico State University Extension suggests autumn or late winter before growth begins; in most of Canada the ground is frozen in late winter, so early spring after the thaw works best.
- Dig around it and look for roots of its own below the shoot.
- Cut it free from the parent root with a sharp spade, keeping as much of its own root and soil as you can.
- Replant at once at the same depth in prepared soil, or in a large pot to grow on for a year. Water it well.
- Mulch it, and keep it watered through its first summer. New Mexico State University Extension adds that a fall-planted sucker should be mulched through its first winter.
Check for grafting first. Some lilacs, especially tree-form ones, are grafted onto another plant's roots. Suckers from below a graft come from the rootstock, not your lilac; if a sucker's leaves look different from the parent's, it is a rootstock shoot and will not grow into the same plant. Suckers from an own-root common lilac, the kind at most old farmsteads, are what you want.
Be patient. A sucker has to grow into a shrub before it blooms; expect several years.
Raspberries spread and are propagated from root suckers in the same way; see transplanting and propagating raspberries.
Aftercare
- Water deeply about once a week through the first summer, more in heat; the root ball lost much of its root system.
- Mulch 5–8 cm deep over the root area, kept back from the stems.
- Do not feed it the first year. University of Minnesota Extension advises waiting until a lilac is established, 2 to 3 years, before fertilizing.
- Expect few flowers for a year or two while it regrows roots.
- Prune only right after bloom once it flowers again; see when to prune lilacs.
Frequently Asked Questions
When is the best time to transplant a lilac?
While it is dormant: early spring before the buds break, or fall after the leaves drop. Iowa State Extension gives both windows for lilacs and other deciduous shrubs. In most of Canada early spring, as soon as the ground thaws, is the safer choice, because a fall-moved lilac has less time to root before the ground freezes.
How do I transplant a large lilac bush?
Water it a few days ahead if the soil is dry, tie the stems together with twine, and dig a root ball whose radius is about half the distance from the outer branches to the centre, about 30 to 38 cm deep, as Iowa State Extension describes. Cut under it, wrap it in burlap and lift it by the ball, not the stems. Replant right away in a hole twice as wide and as deep as the ball, then water thoroughly. Iowa State advises home gardeners to move only shrubs about 1.5 m (5 ft) tall or less; bigger lilacs need a professional with a tree spade, or you can move a sucker instead.
How do I propagate a lilac from a sucker?
Choose a sucker, a shoot coming up from the roots a little way from the main plant, that has grown for a season or two. Dig around it, check that it has roots of its own, and cut it free from the parent root with a sharp spade. Replant it at once at the same depth, water it well and mulch it. New Mexico State University Extension suggests autumn or late winter before growth begins; in Canada early spring is usually easiest.
Will a sucker grow into the same lilac?
Usually, if the lilac grows on its own roots. A sucker is genetically identical to the root it grew from, and New Mexico State University Extension notes that lilacs are usually not grafted, so the new plant will normally be the same variety. If your lilac was grafted onto another rootstock, suckers come from the rootstock and will be a different plant: their leaves often look different.
How long until a transplanted lilac or sucker blooms?
A moved lilac often sulks for a year or two, with few flowers while it regrows roots. A sucker takes longer: it has to grow into a shrub first, often several years. University of Minnesota Extension notes that a newly planted lilac may take 1 to 2 years to bloom.
Can I move a lilac in summer?
Avoid it. A lilac in full leaf loses water faster than a cut-down root ball can replace it. Wait until fall after the leaves drop, or until early spring.
Where should I replant a lilac?
In full sun, 6 hours or more, in well-drained soil, with room for its mature size, as University of Minnesota Extension advises. Avoid low, wet spots.